This allows a device simulator to specifically name the units that it uses
for different purposes. This info is visible in the output of SHOW QUEUE
and debug output.
Once specified or dynamically determined (as previously occurred with
each call to sim_uname()), that name is saved for fast delivery on subsequent
calls. This will remove some overhead when running with debugging on.
Added debug CHECK option to the sim_timer_activate_after() to verify
that coscheduled events actually have sim_activate_time_usecs() results
which are consistent with each other.
Additionally, coschedule tick processing now properly counts down
pending coschedule queued activities.
- Add support to query remaining usecs on pending events.
- Generalized the sim_interval adjustment in sim_idle to allow more than
a single decrement.
- More overhead reduction when idling.
- Carry usec values as double through out to fully support long wall clock
delays.
Also:
- allow a timer to dynamically stop itself (by calling sim_rtcn_calb
with tps=0), and then to start the internal timer to provide a calibration
baseline if necessary.
- Fix coschedule interval computation when the queue is empty.
- Properly select the correct timer for coscheduling without a specific tmr
- Properly adjust the coschedule queue's next time value when entries are
canceled.
- Cleaned up throttling to behave well with all potential throttling rates and
to make visible what is happening when boundaries are reached.
Previously only the actual size of the container file was used when
attaching a disk. This was correct only when the size of the container
file actually aligned with the simulated disk drive. disks created with
sim_disk_attach automatically write to the last sector of a simulated
disk file when the disk is created. Therefore, auto sizing worked correctly
for any disk created with sim_disk_attach.
Disk images created with simh prior to 4.X would only write to the
portions of the disk drive when the simulated system writes data. These
disk images would only be properly sized if the simulated operation of
the disk had actually written to the last block of the disk. Auto sizing of
these disks would usually size the resulting disk incorrectly and strange
behaviors might occur when using such an incorrectly auto sized disk.
Fixes#357
The RUN command implicitly resets all devices which may have unexpected
consequences for a novice user.
The logic now produces a warning about this side effect when more than one
RUN command is executed in the same simulator session.
An explicit RESET command suppresses this warning for a subsequent RUN
command.
A RUN command with the -Q switch also suppresses this warning.
