- Recent Linux versions don't install ifconfig by default and now use
the new ip command for network details.
- Avoid writing command results to a temp file and use popen instead.
Change test for -e (exists) instead of -d (directory) so that the .git
entry is detected correctly and git version stamp logic runs as in any
other git repo. The .git entry is a file when the repo is a submodules
and possibly other obscure cases like multiple worktrees.
fixes#988
* Properly handle the case when a disk is not attached.
* Add register access for debugging.
* Assert DRQ as well as IRQ for software that checks DRQ.
* Add API to get the number of heads for the currently-selected
disk.
* Follow SIMH conventions for debug logging.
* Add ability to debug IMD from the wd179x debug settings.
Tests:
* Format and disk access on Cromemco CP/M 2.2, CDOS, 86-DOS,
MS-DOS 1.25, OASIS 5.6.
The ImageDisk sectsize field was incorrectly set to the number of
bytes in the sector, when it should be an index as follows:
00 = 128 bytes/sector
01 = 256 bytes/sector
02 = 512 bytes/sector
03 = 1024 bytes/sector
04 = 2048 bytes/sector
05 = 4096 bytes/sector
06 = 8192 bytes/sector
Tested disk formatting on MS-DOS 1.25, Cromemco CP/M 2.2,
Cromemco CDOS, OASIS 5.6.
The AB Digital Design B810 RAM card is a 256K Dynamic RAM card
with onboard refresh logic. AltairZ80 support emulates four of
these cards for a total of 16 banks.
As used for the OASIS operating system, the B810 is configured
with common memory at the low addresses (0000h-3FFFh) with 16
banks of 48K from 4000h-FFFFh.
In order to have the common memory appear from 0000-3FFFh, set
the COMMONLOW register to 1:
D COMMONLOW 1
Custom TTL design by Marvin Minsky. There are two displays: one
raster scan for bitmapped characters, and another random scan for
vector graphics. There is also a keyboard, and a UART for talking
to a host computer.
The computer is normally booted off a ROM which reads and starts a
secondary loader from the UART. The loader is responsible for reading
the payload, which comes in checksummed blocks. The LOAD command
accepts files in same format.
